1) Take your eye pin (EP725)

Start your beadwork.


3) Bring the eye pin through the center hole of the bead cap (BC838) and make a loop.

4) Attach the loop to the earring (EW005).

5) Take a headpin (HP215).

6) Attach 1-3mm Jet Bicone (AC3398) to a head pin and make a small loop just above the top of the bead.

7) Cut off excess headpin.

8) Repeat for a total of 2-3mm Jet Bicones dropping down. And 1-4mm Jet crystal.

9) Attach these to the bottom part of your beaded eye pin. Be sure to place the 4mm drop in the center.

10) Take a headpin (HP215)

Start your beadwork.


11) Make a loop at the using your round nose pliers.

12) Repeat 3 more times for a total of 4 beaded headpins.

13) Take a Headpin (HP215)

Start your beadwork.

14) Make a loop just above the last bead.

15) Cut off excess wire.

16) Repeat for a total of 2 beaded head pins. Set aside.

To Finish.

17) Attach 2 of the longer beaded headpins to the outer circles on the bead cap side by side.

18) Attach 1 smaller beaded headpin to the outer circle of the bead cap next to the longer one.

19) Attach the other 2 longer beaded headpins side by side to the outer circles of the bead cap.

20) Attach your last shorter beaded headpin to the last circle on the bead cap.

You should have 2 long ones together and a short one and two long ones again and a short one

Repeat all of the steps above for your other earring.