1) Take the 28" length of wire (BW615) and thread on one crimp tube (BD314) and one eye glass holder (EY200). Take the wire around and back through the crimp tube (BD314). Pull the crimp tube up to the eye glass holder until it's fairly snug against it (not too tight, you want to allow some movement). Crimp the tube with your crimping pliers (PL125). Cut any excess wire off with your side cutters (PL495)

2) Start your beadwork. (the following is for one half of the eye glass holder, to complete the other half of the necklace, follow the list up from bottom to top)

To Finish.
3) Thread on the last crimp tube (BD314) and the other eye glass holder (EY200). Take the wire around and back through the crimp tube (BD314). Pull the wire so that the crimp tube is fairly snug against the eye glass holder (EY200). (Not too tight remember) Crimp the tube with your crimping pliers (PL125) and cut off any excess wire with your side cutters (PL495).

4) Attach the eye glass holders to the arms of a pair of glasses and adjust to fit. You're ready to go!