Instructions.

1) Take the Filigree and begin to SLOWLY wrap the ends around the largest section on the wrap and tap pliers. After bending both sides evenly, step down a section on the pliers and continue to wrap the filigree. Continue adjusting and wrapping until you have the size desired.

To Finish.

2) Mix equal parts of epoxy on a piece of paper with a toothpick. Apply a very small amount to the back of the Crystal Volcano Crystal and stick this to the very middle of the filigree. Repeat this step for the other eight Crystals, sticking them to the outside points on the filigree. Allow the ring to cure completely for a day before wearing.