1) Take 20" of Beading Wire, and thread on one Crimp Tube, and one half of the Toggle Clasp. Bring the wire around and back through the Crimp Tube. Slide the Crimp Tube close to the clasp and crimp it using your Crimping Pliers. Cut the excess wire using your Side Cutters.

2) Start your beadwork.

4) Repeat this pattern from * for all of the beads, finishing the sequence with a Sapphire AB round, a Night Blue Pearl, and a 3mm White Opal Bicone. Then, thread on the last Crimp Tube, and the other half of the Toggle Clasp.

To Finish.

5) Thread the Beading Wire back through the Crimp Tube. Pull the wire tight until the Crimp Tube is snug against the clasp. Crimp the tube using your Crimping Pliers, and cut excess wire as close as you can to the crimped tube using your Side Cutters. Enjoy!