2 Swarovski Bicone 5328 3mm Light Siam AB (AC3314)
2 Swarovski Cubes 5601 4mm Crystal Copper (CU4401)
4 Swarovski Daisy Spacer 3700 10mm Crystal Transmission (DS1414)
2 Swarovski Daisy Spacer 3700 8mm Crystal Transmission (DS8414)
2 Swarovski Daisy Spacer 3700 6mm Crystal Transmission (DS6414)
2 Gold Plated Head Pin 1.5" 21 gauge (HP152)
2 Gold Plated French Hook Wire Flat with Spring (SH302)

Instructions.

1) Take one of the Headpins and thread on one Crystal Copper Cube, two 10mm Daisy Beads (make sure the effect side, or shiny side is faced toward the cube), one 8mm Daisy Bead, one 6mm Daisy Bead, and one Light Siam AB Bicone.

2) With your Chain Nose and Round Nose Pliers, make a simple loop with the remaining Headpin wire. Use your Side Cutters to cut off the excess wire.

3) Open the loop at the base of the Ear Wire the same way that you would a jump ring (side to side, not out). Slide the simple loop that you just created onto this loop, and then close the loop on the Ear Wire securely.

To Finish.

4) Repeat all steps to create the other earring.