1) Take one end of the 8" length of wire (BW018) and thread on one Crimp Tube (BD364). Bring the wire through the small loop on the toggle clasp and back through the Crimp Tube. Pull the wire so that its snug against the clasp (not too tight though, you need to allow a little movement with the clasp) and crimp the tube using your Crimping Pliers (PL125). Cut off any excess wire tail with your Side Cutters (PL483).

2) Start your beadwork.
** Repeat this beading pattern 5 more times.

3) Thread on the final 6mm Jet Round Bead (RB6398), a 4mm Jet Bicone (AC4398), and the final Crimp Tube (BD364). Bring the remaining part of your wire through the loop on the other end of your toggle clasp and back through your Crimp Tube, Bicone and Round Bead. Pull on the tail of the wire until the clasp are fairly snug against one another and the rest of the bracelet. (Allow for some slack by the crimp tube for slipping the Crimp Covers over) Crimp the tube with your Crimping Pliers (PL495). Cut off any excess wire with your Side Cutters (PL483).

To Finish.
4) Attach a Crimp Cover (BD520) over each of the crimped tubes and use the first indent in your Crimping Pliers to close the opening of the crimp cover around the crimped tubes. You're done!

Quantity of Items Needed
2 Swarovski Bicone 5328 4mm Jet (AC4398)
12 Bead Cap - Scroll 11x6mm Pewter Antique Silver Plated (BC4057)
2 Crimp Tube Seamless 2x2mm Silver Plated (BD364)
2 Crimp Cover 4mm Silver Color (BD520)
10" Beadalon Wire .018" 30ft Bright Silver Color 19 Strand (BW018)
1 Toggle Clasp - 15x19mm Pewter Antique Silver Plated (CL1003)
6 Swarovski Graphic Bead 5520 12x10mm Indicolite (GB2923)
7 Swarovski Round 5000 Bead 6mm Jet (RB6398)