1) Cut 15in. length of Beadalon beading wire (FW018).

2) Thread one BD315 onto wire, then thread wire through back of BT4603, across the top and back down through the opposite hole.

3) Thread wire back through BD315. Slide crimp tube (BD315) up wire until flush with BT4603.

4) Crimp tub using PL125 and cut off excess wire.

**Reminder, you will only be beading with one strand of wire**

5) Start your beadwork.

6) String three of the same color bead, then three of the next color, repeating until the pattern is complete.

7) Take the 1 3/8" chain (CN055), diving into one 15mm piece and one 20mm piece.

8) Thread BD315, then 17 of the 3mm Jet Bicones (AC3398).

9) Take the two lengths of chain that were divided in the previous step and thread them on with the remaining two AC3398.

10) Thread end of wire back through the BD315 to create a loop, crimp using PL125 and cut off excess wire.

11) At the end of each length of chain (CN018), ,take one jump ring (JR605) and open using PL490 and PL491. While the jump ring is open, thread one RC6200, then one RC8200, followed by the reamining RC6200.

12) Close the jump ring to secure the Crystal Single Loop channels to the Sterling Silver Chain.

13) Repeat these finishing steps for the other piece of chain and single loop channels (RC6298, RC8298)

Quantity of Items Needed