1) Take the 22" length of beading wire (BW015) and thread on one Crimp Tube (BD314) and one half of the Hook and Eye Clasp (CL024). Take the wire around and back through the crimp tube.
Pull until the crimp tube is fairly snug against the clasp half and then crimp the tube securely with your Crimping Pliers (PL125.) Cut off any excess wire with your Side Cutters (PL495).

2) Start your beadwork.

3) Thread on the last Crimp Tube (BD314) and the other half of the Hook and Eye Clasp (CL024). Take the wire around and back through the crimp tube. Pull the wire tight to remove any slack in the necklace and to have the crimp tube cinch up fairly close to the other half of the clasp. Crimp the tube with your Crimping Pliers (PL125). Cut off the excess wire with your Side Cutters (PL495).

4) Open up the Triangle Jump Ring (JR874) the same way you would any other jump ring, but as you're pushing and pulling the jump ring open, widen the jump ring ever so slightly so that it can fit around and through the hole in the Teardrop Pendant (SP6017).

To Finish.
4) Fit the Jump Ring (JR874) onto the pendant and between the two group #1's in the middle of the necklace. Then, carefully close the jump ring the same way that you opened it. Keep in mind that the Jump Ring may not close all the way due to the Pendant. That's okay, just make sure that the Jump Ring has a secure hold on the pendant. Welcome Spring!