1) Take the 1' length of chain and cut two equal lengths that are approx. 5½" long. Take the 14" long beading wire and thread on one Crimp Tube. Take the wire through the last link of one of the lengths of chain. Go around and back down through the Crimp Tube with the wire. Pull so that the Crimp Tube cinches up to the last link and then crimp the tube closed with your Crimping Pliers. Cut away the excess wire with your Side Cutters. Close a Crimp Cover around the crimped tube.

2) Start your beadwork.

** - repeat twice, * repeat five times

3) Thread on a 3mm bead. Open the 10mm Jump Ring and attach this to the pendant. Close the Jump Ring securely and thread the Jump Ring onto the wire, followed by another 3mm bead. Thread the rest of the pearls and crystals onto the wire mirroring the pattern on the other side of the necklace. When the last 6mm Briolette has been threaded onto the wire, thread on the last Crimp Tube and take this through the last link in the remaining length of chain. Take the wire around and back through the Crimp Tube. Pull so that the slack is taken out of the beading, and the Crimp Tube cinches up to the last link. Crimp the tube with your Crimping Pliers, and cut the excess wire with your Side Cutters. Close a Crimp Cover around the crimped tube.

To Finish.

4) Open both of the 4mm Jump Rings and use these to attach each half of the Hook and Eye Clasp to either end of the two links of chain. Close each of the jump rings securely after doing this, and you're all done!