Instructions.
1) Take the 20" length of wire (BW015), and thread on one Crimp Tube (BD315), and one half of the Hook and Eye Clasp (CL1064). Take the wire around and back through the Crimp Tube. Pull the wire so that the Crimp Tube cinches up to the connector loop on the clasp. Crimp the tube closed with your Crimping Pliers (PL125). Cut any excess wire away with your Side Cutters. Use the first indent on your Crimping Pliers to close one Crimp Cover (BD612) around the crimped tube.
2) Slide on of the 4" lengths of Light Blue Rubber Tubing (SG205) onto the beading
wire, followed by one Rondell Spacer bead (RB045), a Swirl Pewter Bead (BD1145),
another Rondell Spacer bead, and the 8" length of Light Blue Rubber Tubing (SG205).
Thread the Tube bead with Loop (BD1139) onto the 8" length of tubing, it will
slide around along this length of tubing, so don't worry about it staying in place
at this point. Thread on another Rondell Spacer bead (RB045), a Swirl Pewter Bead (BD1145), and another Rondell Spacer bead (RB045).
3) Thread on the last 4" length of Rubber tubing, followed by the last Crimp Tube (BD315), and the other half of the Hook and Eye Clasp (CL1064). Take the wire around and back through the Crimp Tube. Pull the wire so that the Crimp Tube cinches up to the connector on the clasp, and then crimp the tube closed with your Crimping Pliers (PL125). Cut any excess wire away with your Side Cutters. Use the first indent on your Crimping Pliers to close a Crimp Cover (BD612) around the crimped tube.
To Finish.
4) Open the 4mm Jump Ring (JR405), and use it to attach the Charm (CM1052) to the loop at the bottom of the Pewter Tube bead with the loop. Close the Jump Ring securely, and it's ready to wear!
